Onicon F-5100 Insertion Manual do Utilizador descarregar pdf (Página 3)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-5100 Insertion Thermal Mass Flow Meter Manual 05/15 - 0663-20 / 18333 Page 3

TABLE OF CONTENTS

1.0 INTRODUCTION ..................................................................................................5

1.1 PURPOSE OF THIS GUIDE .......................................................................5

1.2 TYPICAL INSERTION THERMAL MASS FLOW SENSOR .....................5

1.3 STANDARD FEATURES AND SPECIFICATIONS ....................................6

1.4 ADDITIONAL REQUIRED HARDWARE ...................................................7

1.5 ADDITIONAL HARDWARE THAT MAY BE REQUIRED .........................8

1.5.1 Flow Conditioners .......................................................................8

1.5.2 Additional Remote Mount Cable ................................................8

1.6 WORKING ENVIRONMENT .....................................................................9

1.7 WARRANTY & SERIAL NUMBER ............................................................9

2.0 UNPACKING ....................................................................................................10

2.1 CHECKING TO SEE THAT YOU RECEIVED EVERYTHING ..................10

3.0 INSTALLATION, REMOVAL AND ADJUSTMENT ..........................................11

3.1 INSTALLATION SITE SELECTION ........................................................11

3.2 MECHANICAL INSTALLATION ............................................................. 13

3.2.1 Installation Kits ..........................................................................13

3.2.2 Directions For Standard Installation (new construction) ........14

3.2.3 Directions For Hot Tap Installation (pressurized system) ........14

3.3 INSTALLING THE FLOW SENSOR ....................................................... 15

3.3.1 Determining the Insertion Depth, Inserting the Sensor and

Tightening the Compression Fitting .........................................15

3.4 REMOVING THE FLOW SENSOR ..........................................................18

3.5 ELECTRICAL INSTALLATION ...............................................................19

3.5.1 Analog Output ...........................................................................19

3.5.2 Pulse Output ..............................................................................19

3.5.3 Integral Mount Wiring ...............................................................20

3.5.4 Using the Pulse Isolator Module ...............................................21

3.5.5 Remote Mount Wiring ...............................................................22

4.0 START-UP & COMMISSIONING FOR ONICON INSERTION THERMAL MASS

FLOW SENSORS ................................................................................................23

4.1 DISPLAY ..................................................................................................23

4.2 POWERING THE SENSOR ......................................................................23

4.3 HELPFUL HINTS FOR START-UP & COMMISSIONING ......................23

4.4 START-UP & COMMISSIONING ............................................................. 24

4.5 START-UP & COMMISSIONING WORKSHEET .....................................25

5.0 TROUBLESHOOTING GUIDE ............................................................................26

1 2 3 4 5 6 7 8 ... 32 33

Sem comentários

Onicon F-5100 Insertion Manual do Utilizador Página 3