Onicon F-3100 Series Manual do Utilizador descarregar pdf (Página 12)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-3100 Flow Meter Manual 06/14 - 0670-7 Page 12

• Grounding Rings

Grounding rings are optional accessories that may be required for proper installation.

Grounding rings may be shipped in a separate carton. Remove each and inspect it for

physical damage.

SECTION 3.0: INSTALLATION

The F-3100 Inline Electromagnetic Flow Meter should be installed by experienced plumbers,

electricians and others with related knowledge and experience in the heating, cooling, and uid

metering elds. ONICON will be happy to assist with technical recommendations and to provide

guidance by telephone and/or email. On-site eld engineering, installation and service are also

available at an additional cost.

The installer should use good trade practices and must adhere to all state and local building or other

applicable codes.

3.1 SITE SELECTION

Careful attention during the site selection process will help the installers with the initial

installation, reduce start-up problems, and make future maintenance easier. For example, do not

install the ow meter where it will be difcult for personnel to perform periodic maintenance.

When selecting a site for mounting, consider the criteria under Section 1.6, WORKING

ENVIRONMENT, as well as the following:

• Integral Mount Transmitter

F-3100 Inline Electromagnetic Flow Meters with integrally mounted transmitters are

shipped fully assembled. Remove the meter from the shipping carton and inspect it for

physical damage.

• Remote Mount Transmitter

F-3100 Inline Electromagnetic Flow Meters ordered with the remote transmitter

mounting option will be shipped in one carton that contains the ow sensor body, the

transmitter with mounting hardware and the necessary cable to connect the two together.

Remove each and inspect it for physical damage.

IMPORTANT NOTE

Proper site selection is critical to the performance of this ow meter. The ow meter must be

properly located within the piping system in order to ensure an accurate ow measurement.

IMPORTANT NOTE

F-3100 transmitters and sensor bodies are two parts of one uniquely calibrated system and must

be installed together. Mixing components from other systems will result in signicant calibration

errors.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

Sem comentários

Onicon F-3100 Series Manual do Utilizador Página 12