Onicon F-1100 Series Manual do Utilizador descarregar pdf (Página 47)

11451 Belcher Road South, Largo FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

Turbine Flow Meter Manual 05/14 - 0721-3 / 13518 Page B-8

11451 South Belcher Road, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699

www.onicon.com • [email protected]

04-14

0544-2 / 15955

For Use With Kits: INSTL7, INSTL8

Installation Hardware Instructions

Standard Installation Kit for 1¼” – 2½” Threaded Pipe

For F-1100, F-1200 & FB-1200 Series Insertion Turbine Flow Meters

This kit must be installed prior to lling the system, or into a section of pipe that is isolated from

pressure and ow. Once installed, this kit allows for insertion and removal of the ow meter without

a system shutdown.

Directions:

1. Identify an appropriate location for the ow meter

(see pages 2-4).

2. Install the threaded pipe nipple, close nipple and

ball valve as shown below. Use a paste type

thread sealant. DO NOT use Teon

tape.

3. Flush and ll the system prior to installing

the meter.

NOTE: Before installing the ow meter, read the entire

installation manual.

Important Note

ONICON insertion ow meters

are precision measuring devices

that must be installed according to

the instructions contained in this

document in order to maintain their

accuracy and reliability. Failure to

follow these instructions will result

in erratic operation and reduced

accuracy.

(see Sections 3.1 and 3.2).

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53

Sem comentários

Onicon F-1100 Series Manual do Utilizador Página 47