Onicon System-10 BTU Manual do Utilizador descarregar pdf (Página 16)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

System-10 BTU Meter Manual 03/15 - 0651-16 / 18323 Page 16

Connect the power source to the main unit through the conduit opening located on the

bottom of the main unit. Fasten the power wires to the appropriate screw terminals as

shown. Do not exceed 13 in-lb (1.5 Nm) of torque when tightening.

As power is initially applied to the System-10, immediately conrm that the display is

illuminated and scrolling through the character diagnostic test. The test will begin by

indicating the letter P in every position followed by a countdown from 9 to 0 for each digit,

If this does not occur, disconnect power immediately and re-verify all wiring connections. If

the problem persists, contact ONICON.

60HZ

J2-1

+15

+24

J2-12

20075-50 REV. A

LED1

VAR1

TB1

20075-50 REV. A

TB1

L1 N Not Used

1/4 AMP

L1 N Not Used

WARNING

Disconnect main power before proceeding.

WARNING

Connect the protective earth wire to the lug located in the lower left hand corner of the motherboard.

Protective Earth

Ground

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 56 57

Sem comentários

Onicon System-10 BTU Manual do Utilizador Página 16